Prior to purchasing any shed or horse barn, we recommend that you check with your local government's building/code enforcement office. Building code officials, in addition to supplying the permit (for a fee that varies with the municipality), will also advise on "setback" requirements, which will determine where the shed can be placed in relation to front, side and rear property lines. Additionally, there may be any number of restrictions or requirements a property owner must meet depending on location, how your property is classified (i.e. residential, farm, etc.) and whether a shed (or barn) is designated as a "permanent" or "temporary" structure based on the size of the building or how it is constructed. Residents of subdivisions also should check any subdivision regulations concerning detached buildings.

Since all municipalities have differing regulations and requirements, we are unable to give advice on exactly what may be required of you. Taking care of these issues is the responsibility of the property owner. We are often asked to supply building specs, etc. as part of the permit process and we are happy to assist whenever possible.

Ultimately, it is your responsibility to check with all municipal agencies and obtain all necessary permits and inspections.

A level pad of ¾" crushed stone, 3" - 4' deep, 1' larger than the size of the shed (for example, a 10' x 14' building would require a pad at least 11' x 15'). This will allow for better drainage around the perimeter of the shed for rain/snow melt dripping off the eaves - especially, if you are not planning on installing rain gutters on the shed. Water splashing directly onto the ground will, eventually, create a muddy area and splash up onto the shed walls. The gravel base prevents this to extend the life of the building.

To prepare a gravel base, remove the sod from an area slightly larger than the pad, level the site by removing dirt where necessary, and spread the gravel to a depth of about three or four inches. Tamp the gravel down with a piece of 4-by-4 or metal tamper until it is evenly distributed and the site is flat and level.

A "frame" of pressure-treated 4x4's or cement block will help keep the stone in place and create a neater appearance; however, it is not required.

OR

A level concrete slab between 3' - 4' thick and at least a foot larger than the building in length and width, as with the gravel pad.

OR

Cement pillars, with or without tie-downs, are required by some municipalities. Check local regulations for quantity and recommended placement.

NOT RECOMMENDED: Cinder blocks. Inevitably, there will be some "settling" after your shed is delivered and placed on site. Placing a shed up on cinder blocks greatly increases the risk that your shed will settle unevenly. This can create twisting and offset door and window frames. Additionally, delivery and placement of shed can be with more difficult with cinder blocks as a base.